your cart

 

You have no items in your shopping cart.

 
 

How to Setup and Install Your New MyT Series Ping Pong Table

July 28, 2016 by Ben Nau

The day has finally come! Your brand new MyT ping pong table has arrived and now it's time to get setup so you can start UnPlugNPlaying with friends and family. There's no need to stress out, these tables are amazingly simple to setup and you can go from box to playing in as little as 15 minutes. The following gifs should help you get going in no time and explain how to setup your new ping pong table.

How To Setup Your New MyT Series Ping Pong Table

Step 1: Clear Some Space

Each of our tables is the regulation 9' long and 5' wide, but you'll also need space to move around when you play. We recommend you give yourself about three extra feet on each side and five feet on each end of the table for optimal play room. However, you can get away with less if space is at a premium. 

It's ok, because while professional players tend to use all the space available to play, most other players usually don't move around near as much. You'll most likely be ok if you have only a few feet of free space around the table.

Space Required for Ping Pong Table

Step 2: Open The Box

Lay the box flat on its largest side and use a box opener or some other sharp object to cut all the taped seams. Lift off the top layer of cardboard and protective packaging and discard. Have friend help you lift each table side out of the box and you're ready to attach the legs. 

Step 3: Attach The Legs

The T-shaped legs come with the casters already installed. All you have to do is attache them to the table. Simply lift and extend the base frame from the table and slide the legs into each slot on the frame, making sure to align the red arrows. To help with orientation, the legs will point at the players, not the side of the table. 

Using the included wrench, insert and tighten the bolts to secure. After installation, with the legs extended and locked in place, have someone help you rotate the table so it is top-up and resting on its new legs. Repeat for other half of table, placing both halves together to prepare for net installation. 

If necessary, use the built-in levelers on each of the four outer legs to level the table.

How to Instal the Legs on your new MyT Series Ping Pong Table

Step 4: Setup & Install The Net

Unfold the net and simply insert the metal pin into the net and slide the pin/net into the post to secure. Then, depending on your net type, you will either clip it or hand screw it on to the seam between the two table halves. Use the string/beads to tension the net once fully installed. The net should be taught and without sag in the middle. 

How to Setup and Install the Net on a MyT Series Ping Pong Table

Step 5: Start Playing

We don't think you'll need directions here. But if you want to brush up on the rules of table tennis, or need some tips to improve your game, we're always here to help! Just drop us a line, give us a call at 866.577.5291 or use the online chat to ask a real human expert some questions about the game or your new MyT Series ping pong table. 

UnPlugNPlay with Killerspin

Leave a Reply